TestIT:Configuration S11

6.3.9 S11

S11 is a development of S10.

Setup fields:

• Configuration
• Symbols
• Recipes
• Test device

Configuration:

1. Write the device name and device description (required)
2. Select if the device is active or not
3. Select the following:
   1. IP Address – Standard 192.168.1.176
   2. Port – Standard 2001
   3. Model – Version of firmware in the S10
   4. Recipe Handling – Where to get recipes from; TestIT or Moscura
   5. Log measure – Select only to store measurement values
   6. Log folder path – Path of folder to store log in
   7. Graph Y axis min – Set a minimum for the Y axis. Auto if 0.
   8. Graph Y axis max – Set a minimum for the Y axis. Auto if 0.
   9. Graph secondary Y axis min – Set a minimum for the secondary Y axis. Auto if 0.
   10. Graph secondary Y axis max – Set a minimum for the secondary Y axis. Auto if 0.
4. Press Save

Symbols:

1. Press the symbols tab
2. Select the wanted symbols

Recipes:

1. Select Open test area symbol and the recipes will be shown
2. Add a new recipe
   1. Press New
   2. Write the recipe name (required)
   3. The optional spaces: Type, Fill, Stab, Measure, Vent, Misc
3. Copy the recipe
   1. Press Copy
   2. Write a new recipe name
   3. Press Save
4. Delete the recipe
   1. Choose the wanted recipe
   2. Press Delete and accept

Test device:

1. Select the test symbol and it will open a new tab
2. To start the test, Press Connect
3. To stop the test, Press Disconnect

6.3.9.1 Commands

Commands in S11 are:

• MeasureStartsS11
• MeasureGetS11